Kemppi X8 - Page 28

X8 MIG WELDER 2.4 Installation
b) Push the rear axle through the opening in the bottom of the rear side of the unit and set
the axle in the middle.
c) Slide the two wheel spacers (1) onto the axle.
d) Slide the two wheels (2) onto the axle.
e) Slide the two washers (3) onto the axle.
f) Slide the two retaining rings (4) on the axle, until they lock into the groove on the axle.
OPERATING MANUAL | EN 28
©
KEMPPI 2017 | 1817