X8 MIG WELDER 2.4 Installation
3 2 1
Max. 20 Nm
g) Place the gas cylinder on the cart.
h) Fasten the straps in the cart around the gas cylinder.
2.4.2.3 Installing optional X8 Cooler
If your setup does not include X8 Cooler, you can skip these instructions.
Caution:
X8 Cooler must be installed by authorized service personnel. Do not open the covers of
X8 Power Source.
OPERATING MANUAL | EN 33
©
KEMPPI 2017 | 1817
To Next Page
Loading...
