X8 MIG WELDER 2.4 Installation
c) Insert cover plugs to the open ends of the wheel set.
d) Place the upper part of the gas cylinder cart on the wheel set, and push it down until the
claw fastens over the transportation handle.
3 2 1
e) Attach the upper part of the gas cylinder cart to the wheel set with two bolts (1) and
washers (2, 3) from both sides.
f) Attach the bottom of the gas cylinder cart to the wheel set with six bolts (1) and washers
(2, 3).
The gas cylinder cart bottom has two alternative settings (the lower setting described in
the figure). The higher setting gives a better ground clearance, but you must lift the gas
cylinder higher.
OPERATING MANUAL | EN 32
©
KEMPPI 2017 | 1817
To Next Page
Loading...
