X8 MIG WELDER 2.4 Installation
2.
Attach a wheel set to the front of the unit.
• To have turning wheels in the front and the back, install the front wheel assembly to the
front of the unit.
For more information, see Installing wheels on page 27.
• To have fixed wheels in the front, install the rear wheel assembly to the front of the unit.
For more information, see Installing wheels on page 27.
3.
Attach the gas cylinder cart to the rear of the unit.
a) Push the axle through the opening in the bottom of the rear side of the unit.
b) Attach the wheel set of the gas cylinder cart to the axle with a bolt (1) and washers (2, 3, 4)
from both sides.
4321
OPERATING MANUAL | EN 31
©
KEMPPI 2017 | 1817
To Next Page
Loading...
