Kemppi X8 User Manual

X8 MIG WELDER 2.4 Installation
8.
Trim the excess filler wire at a slight angle to improve ignition.
9.
Check the gas flow rate.
The welding gun is now ready for use. When not using the gun, you can keep it in the gun holder
on the side of the wire feeder.
2.4.6.2 Replacing consumable parts of welding gun
Select a suitable contact tip, gas nozzle, neck and wire liner according to the job. See also how to
change the feed rolls of the wire feeder accordingly: Replacing feed rolls on page 38.
Compatibility of welding gun parts and models
Table 4: Codes used in the tables
Code Meaning
Standard Part of the standard delivery
X
Compatible, but not part of the the standard
delivery
- Not compatible
Contact tips for water-cooled guns
Contact tip
X8300403500
X8 MIG Gun
400-W 3.5m
X8300405000
X8 MIG Gun
400-W 5.0m
X8300503500
X8 MIG Gun
500-W 3.5m
X8300505000
X8 MIG Gun
500-W 5.0m
W007919
0.8/D10 M8 /
CEP
X X X X
W007920
0.9/D10 M8 /
CEP
X X X X
OPERATING MANUAL | EN 62
©
KEMPPI 2017 | 1817

Kemppi X8 Specifications

General

Brand	Kemppi
Model	X8
Category	Welding System
Language	English