X8 MIG WELDER 2.5 Operation
There is an instruction on the footer above the knob, when the knob has a specific function. A
green circle in the footer prompts the push of the button on the control knob. The adjustable
parameter or value in focus is highlighted with orange.
Figure 7: Control Pad display with the Adjust
footer
Figure 8: Control Pad display with the Select footer
If the selection of the toggle button comes into effect right away, the footer command is Close. If
the change comes into effect after pressing the green button, the footer command is OK.
Control Pad views
There are three main views on Control Pad display: Channel (memory channels), Welding, and
Settings. Toggle between the views with the view buttons. The View menu inside Welding
opens, when you press the middle view button again in the Welding view.
Figure 9: The Channel view button
OPERATING MANUAL | EN 95
©
KEMPPI 2017 | 1817
To Next Page
Loading...
Need help?
General
