Kenwood NX-5200K3 Function Reference

3
Enter a Unit ID.
Refer to Common FUNC “Entering or Deleting a Code” for the entry
method.
0
Using the PF keys
A
numeric character can be selected by pressing the [G] key or the [H]
key, and pressing the Menu ([Q]) or [*] key can confirm the selected
numeric character.
0
Using the keypad
A Unit ID can be entered by pressing the [0] to [9] keys.
4
Initiating an Individual Call.
Press the PTT switch
to initiate a Voice Call. The “
” icon blinks, and the
display changes to “Individual” and the ID name of the target transceiver.
Press the Menu ([Q]) or [*] key to initiate a Paging Call.
If Individual Call Mode has been entered with “Individual + Status” or
“Individual + Short Message”, Status Mode or Short Message Mode is
entered by pressing the [F] key.
Note
The selection screen for the Individual ID List closes at the same time as
pressing
the PTT switch. If selecting an ID and sending an Individual Call
again, reexecute the operations from step 1.
Page
12 : 34
A
M
Individual
UID 1
Delete
Menu Zone +
Individual
TRUCK 824
12 : 34
A
M
Note
0
If the Individual Call Mode previously used is Manual Dialing mode, the transceiver enters Manual Dialing mode by
pressing the Individual key. A selection screen for the Individual ID List will appear by pressing the Function [W]
key.
0
If no ID is registered in the Individual ID List, the transceiver enters Manual Dialing mode by pressing the Individual key
if Manual Dialing is enabled. In this case, the transceiver cannot enter Individual Call Mode if Manual Dialing is disabled.
0
If Transmit LED is enabled, the LED lights red when the transceiver is transmitting. (Refer to Common FUNC Transmit
LED.)
0
If PTT Proceed Tone is enabled, a Proceed Tone (3 beeps) sounds from the transceiver when the transceiver becomes
ready for communications after the PTT switch is pressed. (Refer to Common FUNC Using Sound to Notify the Timing
to Start Communications (PTT Proceed Tone).)
Configuration using KPG-D1/ D1N
0
Assigning functions to the PF
keys on the transceiver (
Transceiver Settings > Key Assignment)
0
Configuring Manual Dialing to be enabled or disabled ( Transceiver
Settings > Personal > Personal Features >
DMR Conventional > DMR)
0
Configuring Selcall on PTT (
Transceiver Settings > Personal > Personality > DMR Conventional > DMR > Selcall
on PTT)
0
Configuring Selcall on PTT (Channel Edit) ( Transceiver Settings > Zone/Channel > Channel Edit > DMR
Conventional > DMR > Selcall on PTT)
1 DMR CONVENTIONAL SYSTEM
1.5 Making an Individual Call
DMR FUNC (K, F)/Ver 2.20 19
CONTENTS INDEX

Kenwood NX-5200K3 Specifications

General

Brand	Kenwood
Model	NX-5200K3
Category	Transceiver
Language	English