Disabling the Transceiver Capability by Remote Control (Stun/ Kill)
The transceiver capability can be disabled by wireless remote control. This function allows an system administrator to
remotely disable the transceiver, for instance, if the transceiver is lost.
The transceiver which has been disabled by this function can be enabled to be usable again by remote control from an
external device using radio communication.
An individually specified transceiver can be controlled by sending a Remote Stun message, Remote Revive message, or
Remote Kill message in Remote Control Mode and by making the transceiver receive the message.
(Refer to Sending a Remote Control Message in Remote Control Mode.)
The following is the transceiver behavior when the transceiver receives a Remote Control message:
Table 1-22 Remote Control
Remote Control
Message
Description
Remote Stun
The transceiver is disabled if the transceiver receives the Remote Stun message.
Whether to accept a Remote Stun message when the transceiver receives the Remote Stun
message can be configured using KPG-D1/ D1N.
Remote Revive
If the transceiver is in the Stun state when receiving a Remote Revive message, the Stun state is
reset.
Remote Kill
If the transceiver receives the Remote Kill message, use of the transceiver is prohibited and all
operations
are disabled. All configuration data of the transceiver is cleared, hence the Kill state is
not reset even if the transceiver receives the Remote Revive message. However, the configuration
data can be written to the transceiver by using KPG-D1/ D1N.
Also, whether to accept a Remote Kill message when the transceiver receives the Remote Kill
message can be configured using KPG-D1/ D1N.
Note
0
This function is applicable only when an individual call is initiated.
0
The received Color Code and the Color Code configured for the transceiver need to match to receive the Remote Stun
message, Remote Revive message, or Remote Kill message.
0
The Stun state is identical to Stun for DTMF and FleetSync.
0
The
Stun state is reset by Remote Revive even if the transceiver entered the Stun state by receiving DTMF or FleetSync
signaling.
0
The Stun state is also reset by receiving the DTMF code (Stun Code + #) or FleetSync status (Status 92).
Configuration using KPG-D1/ D1N
Configuring Remote Stun/Kill
to be enabled or disabled (
Transceiver Settings > Personal > Personal Features >
DMR Conventional > DMR)
1 DMR CONVENTIONAL SYSTEM
1.18 Remote Operation by Radio Communication (Remote Control)
DMR FUNC (K, F)/Ver 2.20 78
CONTENTS INDEX
To Next Page
Loading...
Need help?
General
