KERN ABS-N Series - Page 169

ABS-N_ABJ-NM-BA-e-1715 73
1. Call up menu
 In weighing mode press the MENU button twice
2. Select function
 Press the navigation buttons ( ) repeatedly until
„TOOLS“ is displayed.
 Confirm with PRINT
 Press the navigation buttons ( ) repeatedly
until „TARGT“ is displayed. The current setting is marked
by the stability display ( ).
Further steps depend on the desired setting:
Stability display
( )
Function set/update cancel
yes
ON

Press PRINT and
continue with step 3.
Press TARE and
continue with step 4.
no
off

Press TARE and
continue with step 3.
continue with step 4.
3. Set target value and tolerance
 Press the navigation buttons ( ) repeatedly until the
display to enter the target value „TG.VAL“ appears.
 Press TARE. The current setting will be displayed.
 Use the navigation buttons ( ) to enter the desired
value, see chpt. 3.1.1 „Numeric input“.
 Confirm with TARE.
 Press the navigation buttons ( ) repeatedly until the
display to enter the target value „LM.VAL“ appears.
 Press TARE. The current setting will be displayed.
 Use the navigation buttons ( ) to enter the desired
value, see chpt. 3.1.1 „Numeric input“.