KERN ABS-N Series - Output Timing Change Function

80 ABS-N_ABJ-NM-BA-e-1715
16.2.3 Output Timing Change function
This function allows to select if the data output shall ensue with stable or instable
weighing value after pressing PRINT.
1. Invoke Data Output menu
 Press PRINT for 3 sec. in weighing mode.
2. Select function
 Press the navigation buttons ( ) repeatedly
until „APL.PRN“ is displayed.
 Confirm with PRINT
 Press the navigation buttons ( ) repeatedly until
„PRINT.F“ is displayed.
 Confirm with PRINT. The current setting is marked by the
stability display ( ).
with ( )
Instantaneous data output without waiting
until the stability display appears
without ( ) Data output only after stability display
 Change using TARE.
3. Return to weighing mode
 Press ON/OFF repeatedly or for 3 s.