ABS-N_ABJ-NM-BA-e-1715 57
14 Application Functions
• The application functions can be combined with the check weighing or
target function (see chpt. 14).
• The balance starts in the mode, in which it has been switched off.
• For switching over between application and weighing mode, press MENU
for 3 sec.
14.1 Parts counting
With parts counting you can either count parts into a container or remove parts from a
container. To count a greater number of parts the average weight per part has to be
determined with a small quantity (reference quantity). The larger the reference quantity,
the higher the counting exactness. High reference must be selected for small parts or
parts with considerably different sizes.
1. Enable function and set reference
Call up menu
In weighing mode press the MENU button twice
Select piece counting mode
Press the navigation buttons ( ) repeatedly until
„APL.FUNC“ is displayed.
Confirm with PRINT
Press the navigation buttons ( ) repeatedly
until „PCS“ is displayed.
Press TARE. The display shows the currently set
memory location.
Enter memory location for reference
The balance offers the possibility to store five different
piece weights at the same time.
Press the navigation buttons ( ) repeatedly until the
desired memory location is displayed, then
press TARE.
Display, if no piece weight is stored
Display, if a piece weight is stored
To Next Page
Loading...
Need help?
General
