Controls
https://www.ketron.it/images/ketron/Manuali_HTML/SD40/english/15_controls.html[13/05/2020 17:02:13]
of variables of the percussion instruments during performance.
USB MIDI IN KEYBOARD:On MENU → CONTROLS, the USB MIDI IN KEYBOARD or GM
selection function is inserted. If you connect a midi usb device (for example a midi keyboard), this function allows
you to assign the receiving port to the MIDI KEYBOARD or to the MIDI GM (can be saved in CUSTOM
STARTUP).
- SPLIT LOCK: Allows to"lock" the Split on Player Mode.
ASSIGN VOL.5 TO LOWER :Allows to change the volume of the Lowers by a potentiometer
num. 5 RIGHT. The CHORD volume in this mode only acts in automatic Chords. The function can be saved in
CUSTOM STARTUP
- DRY ON STOP: Apply ByPass effect (DRY) on the microphone when the Player is on STOP. With this
utility, the singer will not have to turn off the effect manually in the case of any presentations, comments etc etc.
- MAIN TRNSP ON PLAYER: With the selected function (yellow icon) using the transpose applies
transposition on Voice / Arranger Section which will be shared with the PLAYER section. With the unchecked
(blue) selection Transposer will operate only on the Voice / Arranger Section without affecting the PLAYER
Section
- MAIN LEVEL: This is the main volume of the instrument that may be set on this menu either by using the
relevant box or the corresponding virtual knob using the Dial. The main output may also be muted.
- AUX / HEADPHONE LEVEL: On this menu you may adjust the volume of the headphones or
Mute them, following the steps described for the Main Level.
- FADE: Inserted MENU → CONTROLS → Fade Mode function that sets different fading speeds, Normal,
Slow1, Slow2, Fast1, Fast2. Can be saved on Custom start up.
MENU
To Next Page
Loading...
