EasyManuals Logo

Keyscan CA250B User Manual

Default Icon
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #103 background imageLoading...
Page #103 background image
Keyscan Inc. Technical Guide (PC109x - 04.15)
103
Figure 69 HID iClass KEYR10
Shield not connected.
Isolate with electrical tape.
6 conductors
shielded 18 AWG
Maximum - 500 ft
(152.4 m)
Shield
ACU Ground
Lug
D1 (White)
D0 (Green)
Red
GND (Black)
LED (Orange)
Black
VDC + -
to separate
DC power
supply
PWR (Red)
Diagram illustrates connections
and cables for Rev A.
Note
Rev B & Rev C do not require
separate power supply. Connect
Red wire to PWR RED terminal
on ACU reader terminal.
Connect shield to ACU ground
lug. 18 or 22 AWG shielded
cable acceptable.
Reader terminal on control board
LED D1
WHT
D0
GRN
PWR
RED
GND
BLK
C1
(BEEP)
LED (Orange)
D1 (White)
D0 (Green)
PWR (Red)
GND (Black)
Pre-alert (Yellow)
Pre-alert
(Yellow)
Yellow (Beeper) used for pre-
alert otherwise isolate and
tape back.
If connecting external sound
device, see Pre-Alert Relay
Option or refer to ACU cut
sheet enclosed with panel for
ACU/OCB8 relay
assignments.
Note - If Pre-alert is
connected, the reader
cannot read any HID 125
kHz-compatible card during
the pre-alert beep.
KI-00206E-03-13
Shield
D1 (White)
D0 (Green)
GND (Black)
LED (Orange)
PWR (Red)
Reader terminal on control board
LED D1
WHT
D0
GRN
PWR
RED
GND
BLK
C1
(BEEP)
Pre-alert
(Yellow)
ACU Ground
Lug
6 conductors
shielded 22 AWG
Maximum - 500 ft
(152.4 m)
Rev. B & C
Connections
Rev. A Connections
to reader
Rev. A 225 mA
Rev. B 75 mA
Rev. C 116 mA

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keyscan CA250B and is the answer not in the manual?

Keyscan CA250B Specifications

General IconGeneral
BrandKeyscan
ModelCA250B
CategoryController
LanguageEnglish