Keyscan CA4500B User Manual

Keyscan Inc. – Technical Guide (PC109x - 07.15)
93
S2 DIP Switch Settings
Review Table 14 for determining S2 DIP switch settings.
Table 14 – S2 DIP Switch Settings
S2 Switch #
Setting
Function
Notes
S2.1
0 = Off
1 = On
Communication Mode
0
Serial Communication
Also see S2.7 & S2.8 in the table.
0
Network Communication
As above.
1
Reverse Network Communication
Applies only to the reverse network
designated control board with the
programmed IP of the host
location. All other boards on
communication bus S2.1 = 0. Also
see S2.7 & S2.8 in the table.
S2.2 & S2.3
Communication Bit Rate
0 0
9600 bit/s
1 0
19,200 bit/s
(not applicable for reverse network)
0 1
57,600 bit/s (CPB-10-2 not supported)
Recommended setting
1 1
115,200 bit/s (CPB-10-2 or CB-485 not
supported)
(not applicable for reverse network)
S2.4 & S2.5
Alternate Panel Serial # Selection
0 0
Factory-assigned serial # *
* Leave on factory assigned setting
unless prompted in the Client
software when inputting panel data.
0 1
Alternate serial #1 – adds 1000 to factory-
assigned serial #
(not supported on Aurora)
1 0
Alternate serial # 2 – adds 100 to factory-
assigned serial #
(not supported on Aurora)
1 1
Alternate serial # 3 – adds 10 to factory-assigned
serial #
(not supported on Aurora)
S2.6
Lockdown
0
Disabled
1
Enabled
CA250 – AI #8 / CA4500 & CA8500
– AI #16 are dedicated lockdown
aux inputs when the control board
is lockdown enabled.
S2.7 & S2.8
Communication Terminal Block Activation
0 0
For direct serial communication connect to RS-
232 (COM4) - TB4 terminal block
0 1
CB-485 and CPB-10-2 communication via CPB/CB
MODULE (COM4) - H1 header
1 0
NETCOMP communication plugged directly into M1
on control board (COM4)
1 1
Program mode for NETCOMP plugged into M1
(COM4) on the control board

Keyscan CA4500B Specifications

General

Brand	Keyscan
Model	CA4500B
Category	Control Unit
Language	English