Error Messages 5
Keysight 34420A User’s Guide 229
750 Invalid channel name
The meter received a
MEAS or CONF command with an invalid
channel specifier.
810 Invalid or unsupported transducer type
An invalid transducer type was detected as a parameter.
820 Temperature out of range for specified transducer
1000 Settings conflict; voltage limit mode has been disabled
After being set to the voltage limited resistance mode, the meter
received a command that changed the settings to an mode or
range not allowed.
1001 Settings conflict; power limit mode has been disabled
After being set to the low power resistance mode, the meter
received a command that changed the settings to an mode or
range not allowed. For example, after the low power mode has
been enabled, a
MEAS:RES (2-wire Ohms) command is received.
To Next Page
Loading...
