Chapter 13 263
Assembly Replacement Procedures
Fan Assembly
Replacing a Fan
1. Refer to Figure 13-27. To replace a fan, it is necessary to remove the 4 plastic
rivets (4) that attach the fan (1) and guard (3) to the fan bracket. To do this
use a small screwdriver to unscrew the rivet and remove it from the bracket.
Figure 13-27 Fan Replacement
2. Position the new fan on the work surface with the arrows pointing to the right
and down.
3. Orient the fan guard so that the rings are on the outside, and that the “V” of the
support legs are pointing to the neighboring fan.
4. With the rivets center posts raised, snap the rivets into place through the fan
grill and fan bracket and into the fan. Screw the center posts into place.
To Next Page
Loading...
