Kguard BR401 - Setting the Device; HDD Setup; PTZ Setup

ENGLISH
Chapter 5: KGUARD Web Client
94
DVR User’s Manual
5.5.5 Seng the Device
Use the Device menu to view the hard disk informaon and setup PTZ.
HDD Setup
You can remotely view the hard disk informaon and select an overwrite opon. To do this, perform the following:
1 On the Main Menu, click Remote Seng.
2 On the le panel, click Device > HDD. The HDD screen appears. The informaon about the installed hard disk(s) on
the DVR are shown.
3 To select an overwrite opon, select the hard disk drive from the table (if more than one is installed).
4 On Overwrite, select an overwrite interval opon (Close/Auto/1 Hour/3 Hours/1 Day/7 Days/30 Days/90 Days).
Note:
If Overwrite is set to Close, the recording will stop once the hard disk drive is full.
5 Aer all sengs are complete, click Save.
« TIP »
To cancel any modicaons and retain the exisng sengs, click Refresh.
PTZ Setup
When a PTZ camera is installed, use the PTZ Setup menu to customize its sengs.
1 On the Main Menu, click Remote Seng.
2 On the le panel, click Device > PTZ. The PTZ screen appears.
3 On Channel, select the channel where the PTZ camera is installed.