Loading condition Switch position
Driver only 0
Driver + Front
passenger
0
Driver + Full pas‐
sengers
1
Full passengers
(including driv
er) +
Maximum permis‐
sible loading
2
Driver + Maximum
permissible load‐
ing
3
High Beam Assist (if equipped)
High Beam Assist is a system that au‐
tomatically
adjusts the headlamp range
(switches between high beam and low
beam) according to the brightness of
other vehicles and road conditions.
Operation condition
1. Place the light switch in the AUTO
position.
2. Turn on the high beam by pushing
the lever away from you.
3. High Beam Assist (
) indicator will
illuminate.
4. High
Beam Assist will turn on when
vehicle speed is above 40 km/h
(25 mph).
5. The details of operation with the
light switch while High Beam Assist
is on are below.
1. If the light switch is pushed
away, High Beam Assist will turn
off and the high beam will be on
continuously.
2. If the light switch is pulled to‐
wards you when the high beam
is off, the high beam will be on
without cancellation of High
Beam Assist. (When you take
your hands off the switch the
lever will move to the middle and
the high beam will turn off.)
3. If the light switch is pulled to‐
wards you when the high beam
is on by High Beam Assist, the
low beam will be on and High
Beam Assist will turn off.
4. If the light switch is turned to
the headlamp position (
) from
AUT
O position, High Beam Assist
will turn off and the low beam
will be on continuously.
5-93
5
Features of your vehicle
To Next Page
Loading...
