CAUTION
n
Tir
e pressure
Do not attempt to drive your vehicle
if the tire pressure is below 250 kPa
(36 psi/2.5 bar). This could result in
an accident due to sudden tire fail‐
ure.
10. Switch off the compressor.
11. Detach
the hoses from the sealant
bottle connector and from the tire
valve.
Return the TMK to its storage location
in the vehicle.
WARNING
n
Carbon monoxide
Carbon
monoxide poisoning and suf‐
focation is possible if the vehicle is
left running in a poorly ventilated or
unventilated location (such as inside
a building).
Distributing the sealant
12. Immediately drive approximately
7~10 km (4~6 miles or about 10
min) to evenly distribute the seal‐
ant in the tire.
CAUTION
Do not exceed a speed of 60 km/h
(35
mph). If possible, do not fall be‐
low a speed of 20 km/h (12 mph).
While driving, if you experience any
unusual vibration, ride disturbance
or noise, reduce your speed and
drive with caution until you can
(Continued)
(Continued)
safely pull off of the side of the
road.
Call for road side service or
towing.
When you use the Tire Mobility Kit,
the tire pressure sensors and wheel
may be stained by sealant. There‐
fore, remove the tire pressure sen‐
sors and wheel stained by sealant
and have the vehicle inspected at a
professional workshop. Kia recom‐
mends to visit an authorized Kia
dealer/service partner.
Checking the tire inflation
pr
essure
1. After driving approximately
7~10 km (4~6 miles or about 10 mi‐
nutes), stop at a suitable location.
2. Connect the filling hose (3) of the
compressor (clip mounted side) di‐
rectly and then connect the filling
hose (3) (opposite side) to the tire
valve.
3. Connect between compressor and
the vehicle power outlet using the
cable and connectors.
4. Adjust the tire inflation pressure to
the cold tire recommended pres‐
sure as indicated on the vehicle’s
7-17
7
What to do in an emergency
To Next Page
Loading...
