REAR CROSS-TRAFFIC COLLISION WARNING (RCCW) (IF EQUIPPED)
System description
Rear Cross-traffic Collision Warning
system
Rear Cross-Traffic Collision Warning
system
uses radar sensors to monitor
the approaching cross traffic from the
left and right side of the vehicle when
your vehicle is in reverse.
The blind spot detection range varies
relative to the approaching vehicle
speed.
WARNING
• Always be aware of road condi‐
tions
while driving and be alert for
unexpected situations even though
RCCW system is operating.
• RCCW system is supplemental sys‐
tems
to assist you. Do not entirely
rely on the systems. Always pay
attention, while driving, for your
safety.
• RCCW system is not substitutes
for proper and safe driving. Always
driv
e safely and use caution when
backing up the vehicle.
System setting and activation
System setting
• The driver can activate the system
by placing the POWER button to the
ON position and by selecting “User
Settings
Driver Assistance Rear
Cross-T
raffic Collision Warning”. The
RCCW turn on and get activated.
• When the vehicle is turned off then
on again, the systems always get
ready to be activated.
• When
the system is initially turned
on and when the vehicle is turned off
then on again, the warning light will
illuminate for 3 seconds on the out‐
side rearview mirror.
Operating conditions
The system will activate when vehicle
speed is below 10 km/h (7 mph) and
with the shifter dial in R (Reverse).
• The system will not activate when
the vehicle speed exceeds 10 km/h
(7 mph). The system will activate
again when the speed is below
8 km/h (5 mph).
The system's detecting range is ap‐
proximately 0.5~20 m (0~82 ft.) An ap‐
proaching vehicle will be detected if
their vehicle speed is within
8 km/h ~ 36 km/h (5 ~ 22.5 mph)
Note that the detecting range may
vary under certain conditions. As al‐
ways, use caution and pay close atten‐
tion to your surroundings when backing
up your vehicle.
6-117
6
Driving your vehicle
To Next Page
Loading...
