• Early:
When
this condition is selected, the
initial Forward Collision Warning is ac‐
tivated earlier than Normal. This set‐
ting maximizes the amount of dis‐
tance between the vehicle ahead, the
pedestrian or the cyclist before the
initial warning occurs.
• Normal:
When this condition is selected, the
initial Forward Collision Warning is ac‐
tivated normally. This setting allows
for a nominal amount of distance be‐
tween the vehicle ahead before the
initial warning occurs.
• Late:
When this condition is selected, the
initial Forward Collision Warning is ac‐
tivated later than normal. This set‐
ting reduces the amount of distance
between the vehicle ahead, the pe‐
destrian or the cyclist before the ini‐
tial warning occurs.
Select 'Late' when traffic is light and
when driving speed is slow.
If the vehicle in front puts on a burst of
speed, the driver can notice the warn‐
ing alarm is early even though the later
option is selected.
Prerequisite for activation
FCA system gets ready to be activated,
when the “Active assist” or “Warning
only” under the Forward Safety is se‐
lected on the LCD display, and when the
following prerequisites are satisfied.
- The ESC is activated.
- The driving speed is over 10km/h.
(However, FCA is activated within cer‐
tain driving speed.)
- When recognizing the vehicle or the
pedestrian or the cyclist in front.
(However, FCA does not activate ac‐
cording to conditions in front and ve‐
hicle systems, but it notices only cer‐
tain warnings.)
- FCA does not operate properly or it
only produces a warning alarms in ac‐
cordance with the driving or vehicle
condition.
- If the warning only under the For‐
ward Safety is selected, FCA produ‐
ces only warning alarms in accord‐
ance with the collision risk levels.
NOTICE
FCA may not operate properly ac‐
c
ording to the frontal situation, the
direction of pedestrian or cyclist and
speed.
WARNING
• Completely stop the vehicle in a
safe
location before operating the
switch on the steering wheel to
activate/deactivate FCA system.
• FCA system automatically acti‐
vates
upon placing the POWER
button in the ON position. The
driver can deactivate FCA system
by canceling the system setting on
the LCD display.
• FCA system automatically deacti‐
vates
upon canceling the ESC.
When the ESC is canceled, FCA
system cannot be activated on the
LCD display. FCA system warning
light will illuminate, which is nor‐
mal.
6-47
6
Driving your vehicle