Driving your vehicle
1525
Safe Exit Warning (SEW)
Function operation
Function warning
Collision warning when exiting vehi
-
cle
䳜 When an approaching vehicle
from the rear is detected at the
moment a door is opened, the
'Watch for traffic' warning mes
-
sage will appear on the cluster,
and an audible warning will sound.
䳜 Safe Exit Warning will warn the
driver when your vehicle speed is
below 3 km/h (2 mph), and the
speed of the approaching vehicle
from the rear is above 5 km/h (3
mph).
Take the following precautions
when using Safe Exit Warning :
䳜 For your safety, change the Set
-
tings after parking the vehicle at a
safe location.
䳜 If any other function's warning
message is displayed or audible
warning is generated, Safe Exit
Warning warning message may
not be displayed and audible
warning may not be generated.
䳜 You may not hear the warning
sound of Safe Exit Warning if the
surrounding is noisy.
䳜 Safe Exit Warning does not oper
-
ate in all situations or cannot pre
-
vent all collisions.
䳜 Safe Exit Warning may warn the
driver late or may not warn the
driver depending on the road and
driving conditions. Always check
vehicle surroundings.
䳜 The driver and passengers are
responsible for accidents that
occurs whilst exiting the vehicle.
Always check the surroundings
before you exit the vehicle.
䳜 Never deliberately operate Safe
Exit Warning. Doing so may lead
to serious injury or death.
䳜 Safe Exit Warning does not oper
-
ate if there is a problem with
Blind-Spot Safety system. The
warning message of Blind-Spot
Safety system will appear when :
- Blind-Spot Safety system sen
-
sor or the sensor surrounding is
polluted or covered
- Blind-Spot Safety system fails
to warn passengers or falsely
warn passengers
To Next Page
Loading...
