PCR-M 17
Chapter 1 General Description
1.2 Options
Interface boards
The functions below are expanded depending on the interface board that is installed
in the PCR-M.
• Selection of AC+DC mode in which DC power is superimposed on the AC
power
• Increased number of memory sets from 3 to 10.
■ GPIB interface board (IB21)
This is an interface board used to control the PCR-M with the GPIB.
■ USB interface board (US21)
This is an interface board used to control the PCR-M with the USB.
■ Analog interface board (EX04-PCR-M)
This is an interface board used to control the output with external analog signals.
The following functions are expanded.
• The voltage of the output AC waveform (sine wave) is varied according to the
input DC signal
(EXT-AC mode).
• The input waveform is simplify amplified and output (EXT-DC mode).
To Next Page
Loading...
