52 PCR-M
Chapter 3 Operation
3.12 Setting the Configuration
The operating conditions are specified.
1.
Press the CONFIG key.
The configuration setting display appears.
The configuration setting switches in order each time the CONFIG key is pressed.
Press the CONFIG key repeatedly until the operating condition you wish to set is
displayed. The measured value display is shown after all configuration settings are
shown.
2.
Turn the rotary knob to set the condition.
3.
To set other operating conditions, press the CONFIG key. To show
another setting display or the measured value display, press the V, F, or
I key.
The voltage setting display, frequency setting display, or measured value display is
shown, respectively.
To Next Page
Loading...
