BioMax2 / KBio2-Online
Installation and Programming Manual
www.kimaldi.com Page 55 of 91
9.6.6. ApplyCFG
Function: It restarts the machine for the new configuration values to be applied.
If bit 3 of CFG_ECHO is enabled (see Subsection 8.1.2.), the BioMax2 / KBio2-Online
electronics may “return the response” to the ApplyCFG instruction. In reality, this will be
the first event after electronics start-up and, therefore, it will only be received if the
CFG_EventCH parameter is correctly configured and, in the event of communications
via UDP, if a remote port other than 0000 is defined.
In general, if this event is enabled, it will be seen when the electronics is started even in
the event of a restart due to an exception. In the latter case, information for the Kimaldi
Electronic Technical Service will be obtained.
Instruction
OP 0x09
NA 0x0000
ARG None
Response None (a soft-reset of the entire machine occurs)
Event
OP 0x09
NA 0x0000 or 0x0014
ARG If 0 arguments, normal start-up.
If 20 arguments, automatic restart after an exception:
Bytes 1..20: information for Kimaldi Electronics.
To Next Page
Loading...