BioMax2 / KBio2-Online
Installation and Programming Manual
www.kimaldi.com Page 35 of 91
Parameter$0D: Canal de Eventos. Normally, the BioMax2/KBio2 electronics always
responds through the same channel from which the instruction is received. However,
there are situations (typically after Reset) where there is no prior instruction and
therefore we have to refer to CFG_EventCH to determine this output channel.
Normalmente, la BioMax2/KBio2 responde siempre por el mismo canal de donde
procede la instrucción. Sin embargo, existen situaciones (típicamente, después de
Reset) donde no existe una instrucción previa y por tanto debemos referirnos a
CFG_EventCH para determinar dicho canal de salida.
Default value:
- 0xFF: Events are not generated until the Host has started communicating.
Note that a spontaneous TCP/IP output cannot be defined.
Table 5: Event Channel identifier
CFG_EventCH Communications channel
$00 UART0
$07
UDP - Bio-OCX (port 5500)
a
a. This requires specifying a remote port other than 0
$08 UDP - KSP (port 6000)
$0C TCP - KSP (port 6600)
$FF Ninguno
To Next Page
Loading...