Kimaldi BioMax2 - Others; Table 10: Other Configuration Parameters

BioMax2 / KBio2-Online
Installation and Programming Manual
www.kimaldi.com Page 42 of 91
For all the parameters described in the table, the configuration value corresponds to
the time in multiples of 10 ms that they are to remain enabled:
- With a correct reading for which CFG_Reader_BuzOK is enabled, the internal
buzzer (CFG_TempBuzz_OK) will be triggered.
- With an incorrect reading for which CFG_Reader_ BuzError is enabled, the inter-
nal buzzer (CFG_Temp-Buzz_Fail) will be triggered.
Permitted values:
- 0xFF: Permanently enabled.
- 0x01 .. 0xFE: Timing in multiples of 10 milliseconds.
- 0x00: Timing disabled.
Default value: depending on parameter (see table)
8.1.6. Others
Parameter$14: Display time-out. Time-out (in cycles) after writing on the Display.
Permitted values:
- 0xFF: legacy value. This is a very conservative Time-out.
- 0x0F: recommended value.
- 0x02: minimum value. Use it if no display is connected.
Default value:
- 0x0F: recommended value.
Table 10: Other configuration parameters
No. Description
Def.
$14
CFG-UI_DisplayTMO
Maximum time-out of the Display $0F