Kimo KIGAZ 210 - Add the Measurement to a Group; Print the Results; Perform a Measurement of Ambient CO; Perform the Measurement

12.5. Add the measurement to a group
The group function has to be activated (see page 18).
Once the measurement is linked to a customer and a boiler, it is possible to add it in a group in the instrument, or create a group:
The analyser proposes to add the measurement to a group.
➢ Go to YES and press OK.
➢ Go to the required group with the arrows and press OK, or create a group (see page 25).
The analyser backs to the measurement screen.
12.6. Print the results
It is possible to print the results on the ticket:
➢ Press the “Print” function button.
Results are printed on the ticket.
See page 17 for the printing configuration.
13. Perform a measurement of ambient CO
2
13.1. Perform the measurement
➢ Connect a CO
2
probe (available as option) on C1 connection on the top of the analyser.
➢ Turn on the analyser.
➢ Go to the “Measurement” menu with the keypad then press OK.
The analyser performs the auto-zero: remaining time and a progress bar display on the screen.
➢ Go to “Ambient CO
2
” with the keypad then press OK.
Measurement launches and the analyser displays the level of ambient CO
2
.
13.2. Link the measurement to a customer
When the measurement has been performed, it is possible to link it to a customer registered in the analyser or to a customer
unregistered in the analyser that must be created.
➢ Press the “Save” function button.
The analyser displays the list of recorded customers.
➢ Select a customer with up and down arrows then press OK or create a customer (see page 23) then select it.
The analyser displays the list of available boilers.
➢ Select the boiler with up and down arrows then press OK or create a boiler (see page 24) then select it.
The analyser backs to the measurement screen.
13.3. Add the measurement to a group
The group function has to be activated (see page 18).
Once the measurement is linked to a customer and a boiler, it is possible to add it in a group in the instrument, or create a group:
The analyser proposes to add the measurement to a group.
➢ Go to YES and press OK.
➢ Go to the required group with the arrows and press OK, or create a group (see page 25).
The analyser backs to the measurement screen.
13.4. Print the results
It is possible to print the results on the ticket:
➢ Press the “Print” function button.
Results are printed on the ticket.
See page 17 for the printing configuration.
30 Perform a measurement of ambient CO2