Kimo KIGAZ 210 - Introduction; Description of the Gas Analyser; Overview of the Analyser

1. Introduction
1.1. Description of the gas analyser
The KIGAZ 210 is a flue gas analyser with two interchangeable sensors (long-life O
2
and CO-H
2
), with additional possibility of a 3
rd
sensor (NO or CH
4
) or is a flue gas analyser with three interchangeable sensors (long-life O
2
, CO-H
2
and NO) with additional
possibility of a 4
th
sensor (CH
4
).
Its main features are the following:
• Auto-zero in the duct
• Protection of CO sensor by solenoid valve
• Led on handle for lightning of dark areas
• External water trap
• LCD screen: 120 x 160 pixels, 50 x 67 mm
• Integrated printer
• 2 thermocouple connections
• 2 Go of memory
The gas analyser is supplied in a transport case in ABS or metallic (optional) with a magnetic protective cover, a differential pressure
kit, an interchangeable flue gas probe of 300 mm length with integrated draft and LED, a Li-ion battery and its charger, LIGAZ-2
software, an USB cable and a calibration certificate. A paper roll for the printer and a filter are also provided.
This analyser is designed to control parameters of flue gas in exhaust duct or heating units. It can not be used in a
permanently way and/or used as an alarm system.
1.1.1. Overview of the analyser
Introduction 7
Handle
Flue gas probe
External water trap
Integrated printer
LCD screen
Single connector for flue
gas probe (TcK+gas) and
draft
LED
Fixing cone
Keypad
LED button
Differential pressure
plug