Stop the engine and lower
the attachment on the ground
prior to disconnecting the lift
rod from the lower link. Check
that the attachment for proper
supporting and there’s pres-
sure remained in the hydraulic
system to remove the lift rod
holding the pin. To eliminate
the remained pressure, move
the hydraulic adjusting lever
back and forth several times.
•
WARNING
When there is no implement at-
tached, fix the lower link to the
check link (LH/RH) so that it
does not contact with the rear
wheel.
Secure the top link to the stor-
age hook.
•
•
NOTE
1. Adjust the check link to control
horizontal sway of the implement.
It is also used to set the implement
on the back of the tractor in center.
2. To adjust the check link, pull out
the pin and adjust it until the de-
sired transverse moving distance
is obtained.
(1) Turn-buckle (2) Check Link
(3) Lock Pin
196O604C
M56O603A
A plate describing how to at-
tach the implement is placed
on the standard implement of
our company.
•
CAUTION
PRECAUTION FOR INSTALLING
/ HOW TO USE TOP LINK HOLES
(1) Top Link
When attaching an implement, con-
nect it according to its position:
1. Adjust an angle of the implements
to the desired position by shorten-
ing or lengthening the top link.
2. Adjusting top length varies accord-
ing to the type of implements used.
To Next Page
Loading...
