S35O702A
T46OA36A
1. If the hose clamps are loose ,
tighten clamps securely.
2. If the hoses and clamps are dam-
aged, you must replace them at
once. Failure to do so could lead
to engine damage.
(1) Air Line Hose (A) Wheel - to - wheel distance at front
(B) Wheel - to - wheel distance at rear
ADJUSTING PROCEDURE
1. Park tractor on a at surface
2. Tur n s te e r in g w he e l so f r on t
wheels are pointed straight ahead.
3. Lower the implement, lock the
parking brake and stop the engine.
4. Measure distance between tire
beads (center) at front of tire and
hub height.
5. Measure distance between tire
beads at the rear of tire and hub
height.
6. Front distance should be 2~8 mm
less than rear distance. If not, ad-
just the tie rod length.
M56O752A
READJUSTMENT
(1) Tie Rod Lock Nut (2) Tie Rod
1. Loosen the lock nut and turn the
turnbuckle to adjust the rod length
until the proper toe-in measure-
ment is obtained.
2. Check the toe-in value after the tie
rod is adjusted.
3. Adjust it again if necessary.
To Next Page
Loading...
