5
-
PB
운운 운운
MX70/MX80/MX90/MX100
5
-
4
CK2810 / CK3010H
8
-
4
Unless the battery is removed
from the vehicle, make sure to
disconnect the negative bat-
tery cable. Cables can be dam-
aged by animals, leading to a
re.
•
CAUTION
1. Check the tire air pressure and
inate the tires if they are low.
2. Install a fully charged battery.
3. Check the fan belt tension.
4. Check all uid levels.
(Engine oil, transmission/hydrau-
lic oil, engine coolant and any at-
tached implements)
5. Remove grease from the ex-
posed cylinder rods.
6. Apply grease to the lubrication
points.
7. Depress the clutch pedal and undo
the latch hook.
8. Get onto the tractor and start the
engine.
9. Check if the instrument panel and
all parts operate correctly while run-
ning the engine for a few minutes.
10. Drive the tractor outside and check
if it is operating properly. Park the
tractor outside and idle engine
for at least 5 minutes. Stop the
engine and visually inspect the
tractor. Check if there is leakage.
USAGE AND DISPOSAL
USING TRACTOR AFTER STORAGE
In order to protect the environment,
comply with the followings.
1. When changing the oil or coolant
by yourself, be careful not to spill
it. Dispose of used oil and coolant
properly according to the appli-
cable regulations.
2. Never leave or discard the expired
tractor or implement without dis-
cretion on your own, but contact
your local KIOTI Dealer to dispose
it according to the regulations.
3. Avoid working under high load as it
can cause excessive exhaust gas,
which is harmful to the environ-
ment.
11. Start the engine, release the park-
ing brake, and check the brake
condition while driving forward. Ad-
just the brake pedals if necessary.
12. Stop the engine and check for leak-
age. Repair any part as required.
To Next Page
Loading...
