1. Disengage the PTO, lower all
implements, place all control le-
vers in the neutral position, set
the parking brake, stop the engine
and remove the key.
PARKING THE TRACTOR
051O120C
(1) PTO Shield (2) PTO Shaft Cap
OPERATING THE PTO
1. Make sure the tractor is completely
stopped, gears are in neutral and all
moving components have completely
stopped before connecting, discon-
necting, adjusting, cleaning or servic-
ing any PTO driven equipment.
2. Keep the PTO shield in place at all
times. Replace the PTO shaft cap
when the shaft is not in use.
3. Before installing or using PTO driven
equipment, read the manufacturer’s
manual and review the safety labels
attached to the equipment.
051O121C
Before driving an implement
through the PTO, always make
sure that all bystanders are
well away from the tractor.
When using the PTO drive with
a stationary tractor, always
make sure that the gears are
in neutral and that the parking
brake is applied.
Before starting up any PTO-
driven implement hitched to
the three-point linkage, lift the
implement to its full height
and check that at least 1/4 of
the total length of the tele-
scopic section of the drive
shaft is engaged.
Ensure that implements and
attachments are properly in-
stalled and that the tractor and
implement PTO RPM ratings
match.
•
•
•
•
WARNING
To Next Page
