M56O728AM56O727A
1. Stop the engine and let it cool.
2. To drain coolant, remove the drain
plug from the radiator and turn
the radiator cap to the 1
st
notch to
release pressure in the radiator.
Then, remove the cap completely.
3. After all coolant is drained, close
the drain cock.
4. Fill with clean water and anti-
freeze.
5. Install the radiator cap securely.
(1) Drain Cock
(1) Reservoir Tank (2) Radiator cap
(A) FULL (B) LOW
6. Add coolant to the reservoir tank
to the "FULL" level.
7. Start and operate the engine for
few minutes.
8. Stop engine and let cool.
9. Check coolant level of reservoir
tank and radiator. Add coolant if
necessary.
7.8 L (2.06 U.S.gal)
Do not remove the radiator
You c an b e bur ned by h o t
steam. Make sure to remove
it after the coolant is cooled
down enough.
Even though the coolant is
-
•
•
CAUTION
To Next Page
Loading...
