(1) Coolant Temperature Gauge
“C” COOL “H” HOT
COOLANT TEMPERATURE
GAUGE
FUEL GAUGE
(1) Fuel Gauge
“E” EMPTY “F” FULL
When the key switch is on, the fuel
gauge indicates the fuel level.
Be careful not to empty the fuel tank.
Otherwise air may enter the fuel sys-
tem.
Should this happen, the system
should be bled (See "Bleeding Fuel
System" in as required in Periodic
Service Section.)
Wait until engine is warm enough.
Do not operate tractor before temp.
1. When the key switch is turned
"ON" this guage indicates the tem-
perature of the coolant. "C" is for
cold, and "H" is for hot.
621O529A 621O530A
CAUTION
To avoid personal injury:
Do not remove radiator cap un-
til coolant temperature is well
below its boiling point. Then
loosen cap slightly to the stop
to relieve any pressure before
removing cap completely.
Be careful not to exceed cooling wa-
ter temperature over heated(red
mark on temp meter) before operat-
ing tractor, always check the amount
of cooling water in the radiator.
To Next Page
Loading...
