DRAFT CONTROL LEVERPOSITION CONTROL
(1) Position Control Lever
(A) “UP” (C) “FLOAT”
(B) “DOWN ”
The position of an attachment can
be freely controlled within the range
of position control, using the lever.
An attachment will completely low-
er when the lever is in the floating
range.
(1) Draft Control Lever
(A) “UP” (B) “SHALLOW”
(C) “DEEP” (D) “FLOAT”
1. The draft control is used to do
draft work with an attachment, like
a plow, attached to the 3-point
linkage.
2. In the floating range, the attach-
ment will completely lower.
3. In the draft control range, the hy-
draulic unit will have a force to lift
the attachment. In this stage, it is
possible to do stable work without
slipping.
621O703A621O702A
IMPORTANT
If the 3-point hitch can not be
raised by setting the hydraulic
control lever to the “UP” posi-
tion after long term storage or
when changing the transmis-
sion oil, follow these air bleed-
ing procedures.
1. Stop the engine.
2. Set the hydraulic control le-
ver to the “DOWN” position
and start the engine.
3. Operate the engine at low idle
speed for at least 30 seconds
to bleed air from the system.
Do not operate until the engine
is warmed up. If operation is at-
tempted when the engine is still
cold, the hydraulic system may
be dama ged.
If noises are heard when imple-
ment is lifting after the hydrau-
lic control lever has been acti-
vated, the hydraulic mechanism
is not adjusted properly. Unless
corrected the unit will be dam-
aged. Contact your KIOTI dealer
for adjustment.
To Next Page
Loading...
