4. Loosen the drain plug of upper
from hydraulic pump and drain the
oil.
5. After draining reinstall the drain
plug.
6. Open the feeding plug on the top
of the hydraulic pump holder and
feed the engine oil.
(1) Drain Plug (2) Feeding Plug
621Oa09a
Oil capacity 0.1 L (0.026 U.S.gal.)
(1) Engine Oil Filter
REPLACING ENGINE OIL
FILTER
621Oa10a
IMPORTANT
1. Remove the oil lter.
2. Put a film of clean engine oil on
the rubber seal of the new lter.
3. Tighten the filter quickly until it
contacts the mounting surface.
Tighten lter, by hand, an addition-
al half turn only.
4. After the new filter has been re-
placed, the engine oil normally de-
creases a little. Make sure that the
engine oil does not leak through
the seal and be sure to check the
oil level on the dipstick. Then, re-
plenish the engine oil up to the
prescribed level.
CAUTION
-
-
-
burn.
To Next Page
Loading...
