STARTING THE ENGINE
(1) Parking Brake Lever
(2) Interlock the Brake Pedals
(A) “PULL”
(B) “DEPRESS”
1. MAKE SURE THE PARKING
BRAKE IS SET
(1) To set the parking brake;
1) Interlock the brake pedals
2) Depress the brake pedals
3) Latch the brake pedals with
the parking brake lever.(Check
that the parking brake lamp on
the gauge board illuminates.)
(2) To release the parking brake
press the brake pedals again.
621O501A
IMPORTANT
Using starting fluid or ether
to start your tractor will cause
damage and void your tractors
warranty.
A good way to start your trac-
tors engine after a long stor-
age period you should pull the
stop knob and turn the key
over. This will allow time for oil
to reach every part of the trac-
tors engine before starting.
To avoid damage to the start-
er and battery you should nev-
er continuously start your trac-
tor for more than 10 second at
a time.
IMPORTANT
Make sure that the parking
brake pedals are fully depressed
before pulling the parking brake
lever up.
To Next Page
Loading...
