(1) Position Control Lever
(2) Lock Bolt
IMPLEMENT LOWERING LIMIT
POSITION CONTROL LEVER
The three point arms are controlled
by the position control lever. The le-
ver is drawn back towards the rear
of the tractor to raise the three-point
arms, and pushed forward to lower
the three-point arms. When the con-
trol lever is pushed completely for-
ward, the three-point is in the oat po-
sition. In the float position the three-
point is free to move up or down with
the weigh of the implement.
621O705A
3-POINT HITCH LOWERING
SPEED
(1) 3-point hitch lowering speed knob
F “FAST” L
“
LOCK”
S “SLOW”
AUXILIARY HYDRAULICS
621O706A
The lowering speed of the 3-point
hitch can be controlled by adjusting
the 3-point lowering speed knob.
CAUTION
To avoid personal injury:
Fast lowering speed may cause
damage or injury. Lowering
speed of implement should be
adjusted to two or more sec-
onds.
CAUTION
Escaping hydraulic uid under
pressure can have sufficient
force to penetrate skin, causing
serious personal injury. Before
disconnecting lines, be sure to
relieve all pressure. Before ap-
plying pressure to system, be
sure all connections are tight
and that lines, pipes, and hoses
are not damaged. Fluid escap-
ing from a very small hole can
be almost invisible. Use a piece
of cardboard or wood, rather
than hands, to search for sus-
pected leaks.
If injured by escaping uid, see
a doctor at once. Serious infec-
tion or reaction can develop if
proper medical treatment is not
administered immediately.
To Next Page
Loading...
