EasyManua.ls Logo

KMT STREAMLINE S50 - Page 165

Default Icon
203 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4. FIRST AID MEASURES
Inhalation: Remove to fresh air. If symptoms develop and persist, get medical attention.
Skin contact: Wash with soap and water. Remove contaminated clothing and shoes. Wash clothing before reuse.
Get medical attention if symptoms occur.
Eye contact: Flush with copious amounts of water, preferably, lukewarm water for at least 15 minutes, holding
eyelids open all the time. Get medical attention.
Ingestion: Do not induce vomiting. Keep individual calm. Obtain medical attention.
5. FIRE-FIGHTING MEASURES
Flash point: Greater than 93ºC (200ºF) Tagliabue closed cup
Autoignition temperature: Not available
Flammable/Explosive limits-lower %: Not available
Flammable/Explosive limits-upper %: Not available
Extinguishing media: Foam, dry chemical or carbon dioxide.
Special fire fighting procedures: Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear.
Unusual fire or explosion hazards: None
Hazardous combustion products: Oxides of carbon. Oxides of sulfur. Oxides of nitrogen. Irritating organic vapors.
Sensitivity to mechanical impact: Not available.
Sensitivity to static discharge: Not available.
6. ACCIDENTAL RELEASE MEASURES
Environmental precautions: Prevent product from entering drains or open waters.
Clean-up methods: Soak up with inert absorbent. Store in a partly filled, closed container until disposal.
7. HANDLING AND STORAGE
Handling: Avoid contact with eyes, skin and clothing. Avoid breathing vapor and mist. Wash thoroughly after
handling. Use only with adequate ventilation.
Storage: For safe storage, store at or below 38°C (100°F). Keep in a cool, well ventilated area away from heat,
sparks and open flame. Keep container tightly closed until ready for use.
Incompatible products: Refer to Section 10.
For information on product shelf life contact Loctite Canada Customer Service at (905) 814-6511.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Engineering controls: No specific ventilation requirements noted, but forced ventilation may still be required if concentrations
exceed occupational exposure limts.
Respiratory protection: Use NIOSH approved respirator if there is potential to exceed exposure limit(s).
2 of 5
21464Item No. : Product name: Loctite(R) 222 Threadlocker Low Strength
KMT 20416099

Table of Contents

Related product manuals