PRODUCT NAME: GERALYN AW 68
---------------------------------------------------------------------------
apparatus is recommended in all situations where airborne contaminant
concentration has not been confirmed to be below safe levels.
Respirator use should comply with the OSHA Respirator Protection
Standard found in 29 CFR 1910.134.
ENGINEERING CONTROLS:
Normal general ventilation is expected to be adequate. It is recommended
that ventilation be designed in all instances to maintain airborne
concentrations at lowest practicable levels. Ventilation should at a
minimum, prevent airborne concentrations from exceeding any exposure
limits listed in Section 2 of this MSDS.
The user may wish to refer to 29 CFR 1910.1000(d)(2) and the ACGIH
"Threshold Limit Values for Chemical Substances and Physical Agents
Biological Exposure Indicies" (Appendix C) for the determination of
exposure limits of mixtures. An industrial hygienist or similar
professional may be consulted to confirm that the calculated exposure
limits apply.
___________________________________________________________________________
______________ SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES _____________
Physical Appearance . . . . . . . . . : Water white
Odor . . . . . . . . . . . . . . . . : Mild petroleum
Physical State . . . . . . . . . . . : Liquid
Water Solubility . . . . . . . . . . : Insoluble
Specific Gravity . . . . . . . . . . : .868
___________________________________________________________________________
_________________ SECTION 10 - STABILITY AND REACTIVITY _________________
INCOMPATIBILITIES:
This product is incompatible with strong oxidizing agents.
DECOMPOSITION PRODUCTS MAY INCLUDE:
Thermal decomposition products are dependent on combustion conditions.
A complex mixture of airborne solid, liquid, particulates and gasses may
evolve when the material burns. Combustion byproducts may include:
oxides of carbon,
incompletely burned hydrocarbons as fumes and smoke.
CONDITIONS TO AVOID:
Avoid contact with incompatible materials and exposure to extreme
temperatures.
POLYMERIZATION:
This product is not expected to polymerize.
STABILITY:
To Next Page
Loading...