EasyManua.ls Logo

KMT STREAMLINE S50 - Page 201

Default Icon
203 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4. FIRST AID MEASURES
Inhalation: Remove to fresh air. If discomfort persists seek medical attention.
Skin contact: Wash with soap and water.
Eye contact: Flush with copious amounts of water, preferably, lukewarm water for at least 15 minutes, holding
eyelids open all the time.
Ingestion: If conscious, drink plenty of water. Do not induce vomiting. Keep individual calm. Obtain medical
attention.
5. FIRE-FIGHTING MEASURES
Flash point: -20°C (-4°F) (estimated)
Autoignition temperature: 465°C (869°F)
Flammable/Explosive limits-lower %: 2.6 %
Flammable/Explosive limits-upper %: 13 %
Extinguishing media: Foam, dry chemical or carbon dioxide.
Special fire fighting procedures: None
Unusual fire or explosion hazards: Vapors may accumulate in low or confined areas, travel considerable distance to source of ignition,
and flash back.
Hazardous combustion products: Oxides of carbon. Oxides of nitrogen. Irritating organic vapors.
6. ACCIDENTAL RELEASE MEASURES
Environmental precautions: Prevent product from entering drains or open waters.
Clean-up methods: Remove all ignition sources. Ensure adequate ventilation. Soak up with inert absorbent. Store in a
closed container until ready for disposal.
7. HANDLING AND STORAGE
Handling: Avoid contact with eyes, skin and clothing. Avoid breathing vapor and mist. Wash thoroughly after
handling. During use and until all vapors are gone: Keep area ventilated - do not smoke; extinguish all
flames, pilot lights, and heaters; turn off stoves, electrical tools and appliances, and any other sources
of ignition.
Storage: Store away from heat, sparks, flames, or other sources of ignition. For safe storage, store at or below
49°C (120°F).
Incompatible products: Refer to Section 10.
For information on product shelf life contact Henkel Customer Service at (800) 243-4874.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Engineering controls: Use local ventilation if general ventilation is insufficient to maintain vapor concentration below
established exposure limits.
Respiratory protection: Use NIOSH approved respirator if there is potential to exceed exposure limit(s).
2 of 4
19269Item number: Product name: Loctite(R) 7649 Primer N

Table of Contents

Related product manuals