PAPER FEED UNIT OF TRAY 3 (7155/7165)
3-K-1
3 DIS./ASSEMBLY
PAPER FEED UNIT OF TRAY 3 (7155/7165)
[1] Removing and Reinstalling the Paper
Feed Unit
Caution:
Be sure the power cord has been
unplugged from the wall outlet.
a. Procedure
(1) Draw out paper feed tray 3.
(2) Loosen the securing shaft screw, and remove
one screw.
(3) Disconnect the relay connector (CN854) and
remove the paper feed unit by lifting.
(4) Reinstall the above parts following the removal
steps in reverse.
[2] Removing and Reinstalling Paper
Feed Tray 3
Warning:
When removing the tray, stand in a proper
position so that you do not hurt your back
and waist. If the tray contains paper,
remove all paper before removing the tray.
Caution:
Be sure the power cord has been
unplugged from the wall outlet.
a. Procedure
(1) Draw out paper feed tray 3.
(2) Remove the paper feed unit.
(3) Remove four screws and remove tray 3 by lifting.
(4) Reinstall the above parts following the removal
steps in reverse.
Relay connector (CN814, 834)
Securing shaft screw
Paper feed unit
Screw
Tray 3
Screws
To Next Page