FIXING UNIT
3-O-3
3 DIS./ASSEMBLY
[5] Replacing the Fixing Heater Lamps
(L2, L3)
Caution:
Do not touch the fixing heater lamp with
bare hands.
Caution1: Install the heater lamp with the man-
ufacturers mark facing the rear.
Caution2: The heater lamp should not touch
the inner surface of the upper roller.
Caution3: When replacing the heater lamp, be
sure to insert the lamp end in the
lamp terminal securely. Also, check
that the Faston terminals are con-
nected correctly.
a. Procedure
(1) Remove the fixing unit.
(2) Remove the fixing unit front cover.
(3) Remove the screw at the front to remove the
lamp fixing plate (front).
(4) Remove the front lamp harness from the harness
guide to remove the two Faston terminals.
Caution: When removing the Faston terminals,
be sure to hold the connector. Con-
nector cannot be removed by pulling
on the harness.
(5) Open the fixing unit (top).
(6) Remove the screw at the far side to remove the
lamp fixing plate (rear).
(7) Remove the two Faston terminals of the far side
lamp.
Caution: When removing the Faston terminals,
be sure to hold the connector. Con-
nector cannot be removed by pulling
on the harness.
(8) Pull out the fixing heater lamps (L2, L3) from the
front side of the fixing upper roller.
Faston terminals
(2)
Screw
Harness guide
Lamp fixing plate
(front)
Faston terminals (2)
Screw
Lamp fixing plate (rear)
Fixing heater lamps (L2, L3)
To Next Page