Introduction
1
Konica 7115/7118 1-13
“Width” and “Length”
Whenever paper dimensions are mentioned in this manual,
the first value always refers to the width of the paper (shown
as “A” in the illustration) and the second to the length (shown
as “B”).
A: Width
B: Length
Paper Orientation
Lengthwise ( )
If the width (A) of the paper is shorter than the length (B), the
paper has a vertical or portrait orientation, indicated by either
“L” or .
Crosswise ( )
If the width (A) of the paper is longer than the length (B), the
paper has a horizontal or landscape orientation, indicated by
either “C” or .
Konica7115_7118.book Page 13 Friday, October 19, 2001 12:02 PM
To Next Page
Loading...
