Reference • Backing Sequence mode
98
5 Program the MIDI channels if the iS35 is played
by a master keyboard or other MIDI controller.
• Bring the cursor to the “Ch” parameter and
assign a MIDI channel to the Extra Track. Normally,
the Extra Tracks are not connected to the MIDI.
6 Move the cursor to the “Ch” parameter and
assign a MIDI channel to the Extra Track.
The Extra Track usually are not connected to the
MIDI.
• Program the MIDI controller to transmit over the
channel of the Extra Track to be recorded. The Extra
Tracks must receive the notes over their own chan-
nel, and not over the special Global channel.
7 Press EXIT/NO to go back to page 1. Then press
REC/WRITE/LYRICS to start recording.
8 Move the cursor to the track (Atr) selected for
the recording using the CURSOR buttons.
9 Use the TEMPO/VALUE or VOLUME/PROGRAM
buttons to select ETr8 instead of ATr.
This operation will program the recording of the
Extra Track 8.
0 Press START/STOP to start the recording.
After a two-measure pre-count, the arrangement
will start playing and the recording will start.
A Play freely.
B When finished, press START/STOP to stop the
recording.
The recording will stop and the REC/WRITE/LYR-
ICS led will go off. The sequencer will go back to
measure 001.
C Press START/STOP again to listen to the song
you have just recorded.
The song will be played from the beginning to the
end. When finished, the sequencer will go back to
measure 001. You can stop the playback halfway by
pressing START/STOP; in this case, press RESET to
return to measure 001.
D Repeat the procedure to record other Extra
Tracks.
Real time tracks
Chord track
Control track
Metronome
Tempo mode
Quantize value
Selected track(s)
To Next Page
Loading...
Need help?
General
