Reference • Song Edit mode
125
Page 2: Playback
The parameters contained in this page control the
playback of the SMF loaded in memory.
Tempo
[40…240]
Metronome tempo, or playback speed of the song.
Normally, it is the tempo recorded in the song. If you
wish to adjust the tempo manually, set the “Tempo
mode” parameter to MAN.
Tr (Track)
[1…16]
Selected track.
Note: In Song Edit mode the terms track and channel do
not coincide. The MIDI channel of each track can be
freely defined on “Page 3: Track parameters”.
Tempo mode
[AUTO, MAN]
Playback mode of the metronome tempo.
AUTO The song tempo will play. The tempo
changes recorded in the track will be
considered.
MAN The tempo will be as defined by the
TEMPO/VALUE buttons (or the DIAL).
The tempo changes recorded in the
song will be ignored.
M (Measure number)
[001…999]
Current measure. With the sequence stopped, you can
choose the measure you wish to start from or continue
the playback. If you move to a measure – or after a
measure – that contains tempo change, program
change or volume change, the data for all the channels
will be updated, except for the ones that are muted. If
you wish to updated these channels as well, change
their channel status and put them in Play. It is not pos-
sible to choose a different measure while the song is
being played back.
Octave
[–2…+2]
Transposition of the keyboard in octaves. Use the
OCTAVE buttons to change this value.
Tempo
Measure number
Octave
Selected track
Tempo mode
To Next Page
Loading...
Need help?
General
