Reference • Song Edit mode
130
8. At the end press START/STOP to exit the event
edit page.
Event filter
To make viewing and searching of the event you wish
to edit easier, you can “filter” the events shown on the
display. While you are in the main page of Event Edit,
press REC/WRITE/LYRICS to access the Event Filter
page. Assign “o” to the type of events you wish to
view, “x” to the type of event that you do not wish to
view. For more information on the various types of
events, refer to the paragraph about this further on.
Press REC/WRITE/LYRICS or START/STOP to get
back to the Event Edit page.
Event types
● BAR (Bar line)
Measure number/Index number
The index number is the event number within the
measure. By modifying this number you can step from
one event to another within the measure. Index
number 0 corresponds to the bar line (i.e. the point that
separates two measures) and the time signature of the
measure.
Time signature
This indicates the time scanning of the measure, i.e.
the number of movements in which it is divided, and
the scanning unit.
● End of track
This display indicates the end of the track.
● Event
Position
[1:00…8:95]
This indicates the position within the measure. The
value is displayed in the form of “quarter:tic” (96 tics
per quarter). If the TIE abbreviation appears, the note
has been tied to the last note in the previous measure.
“Note” events
“Control change” events
“Aftertouch” events
“Program change”
events
“Poly Aftertouch”
events
“Pitch bend”
events
Measure number / Index number
Bar line
Time signature
Position
Event type
To Next Page
Loading...
Need help?
General
