Reference • Disk/Global mode
162
Page 17: Chord recognition mode
This is the mode in which the chords for the automatic
accompaniment will be recognized when the button
selected in the CHORD SCANNLING section is
LOWER.
If you have selected the UPPER or FULL button in
the CHORD SCANNING section, the chord recogni-
tion mode will always be Fingered 2.
ChordRecog (Chord recognition mode)
[FINGERED1, FINGERED2, ONE FINGER]
FINGERED1 If Chord Scanning is set on LOWER,
you only have to play one note
below the split point to obtain a
major chord.
FINGERED2 In order for a chord to be recog-
nized, three or more notes must be
played in the chord recognition area
established by Chord Scanning set-
ting.
ONE FINGER If only one note is played (e.g. C3),
this note will be recognized as the
root of a major chord. If along with
the root, you play the first white key
below the root (e.g. C3 and B2), a
seventh chord will be recognized. If,
along with the root, the first black key
is played below the root (e.g. C3 and
Bb2), a minor chord will be recog-
nized.
Trig (Trigger)
[Note On/Note On & Off]
If the Trigger parameter is set on ON, you can change
the chord by raising one or more notes of the previous
chord, without playing the chord again.
For example, you are playing a C7th chord (C, E, G, B
flat) and the arranger recognizes C7th. If you raise the
B flat, a C major (C, E, G) chord will be composed and
the arranger will recognize a C Major.
This parameter changes the way in which the chords
are recognised while playing on the keyboard.
Note On Chords are recognised when the
notes are played. When the notes
are released, the chord will not be
updated.
Note On&Off Chords are recognised both when
the notes are played and released.
For example, if you play C, E, G, B
flat, the C7th chord will be recog-
nised. If you release the B flat, the C
major chord will be recognised.
Chord recognition mode
Trigger
To Next Page
Loading...
Need help?
General
