Getting Started • Introduction
5
1 Connect the MIDI OUT connector of the MIDI
accordion to the MIDI IN 1 connector of the iS35
using a standard MIDI cord.
2 Press DISK/GLOBAL.
3 Press the PAGE [+] button repeatedly to go to
the MIDI Settings page.
4 Press CURSOR [>] to select <SETUP>.
5 Press the TEMPO/VALUE [+] button repeatedly
(or rotate the DIAL clockwise) to select one of
the MIDI “Accordion” Setups.
There are three “Accordion” setups:
• “Accordion 1” for those who have an accordion
with three fixed channels.
• “Accordion 2” for those who have an accordion
with two channels on the right hand and do not
want to play the iS35 bass.
• “Accordion 3” for those who have an accordion
with two channels on the right hand, want to play
the iS35 bass and have another channel to change
the iS35 Arrangements with Program Change.
For more information on the MIDI setups, see the
chapter “MIDI” on page 51 and the paragraph
“Page 3: MIDI Settings” on page 150.
6 Press ENTER/YES twice to confirm the selection
of the MIDI setup.
The configuration of the MIDI channels and of the
other parameters selected with the MIDI setup will
be saved in the memory (in Global). The configura-
tion will remain saved even if the instrument is tur-
ned off.
Connecting other MIDI controllers
The MIDI configuration may vary according to the
type of controller connected to the iS35. To automati-
cally re-configure the iS35 select a MIDI Setup (see
“MIDI” on page 51 and the “Page 3: MIDI Settings” on
page 150).
To Next Page
Loading...
Need help?
General
